This European Standard specifies the properties of aggregates and filler aggregates obtained by processing natural, manufactured or recycled materials and mixtures of these aggregates for use in hydraulically bound and unbound materials for civil engineering works. It also covers recycled aggregates with particle densities between 1,50 Mg/m3 (1500 kg/m3) and 2,00 Mg/m3 (2000 kg/m3). A list of the source materials that have been considered and are within the scope of this standard is given in Annex A (normative). This European Standard also specifies that a quality control system is in place for use in factory production control and it provides for the evaluation of conformity of the products to this European Standard. This European Standard does not cover the grading properties of unbound mixtures as specified in EN 13285. This European Standard incorporates a general requirement that aggregates will not release any dangerous substances in excess of the maximum permitted levels specified in a relevant European Standard for the material or permitted in the national regulations of the member state of destination (see NOTE 3). NOTE 1 Aggregates used in hydraulically bound and unbound materials for civil engineering works should comply with all the requirements of this European Standard. The standard includes comprehensive and specific requirements for natural aggregates, iron and steel making slag and recycled aggregates, dealing with, for example, the stability of certain basalts, the expansion of certain slags and the constitution of recycled aggregates. For materials from some other secondary sources, however, work is ongoing and the requirements are incomplete. In the meantime, such materials, when placed on the market as aggregates, should conform fully to this standard but may also be required to conform to specific relevant additional requirements at the place of use. Additional characteristics and requirements may be specified on a case by case basis depending upon experience of use of the product, and defined in specific contractual documents. NOTE 2 Requirements for lightweight aggregates are specified in EN 13055. NOTE 3 Requirements for the declaration of the potential of aggregates to release regulated dangerous substances are currently under development. Until such time as these are finalised, attention should be paid to requirements at the place of use. NOTE 4 The Tables in this standard include categories which are common across the four main aggregate standards: EN 12620, EN 13043, EN 13139 and EN 13242. Not all of these categories are appropriate for aggregates for bituminous mixtures. Only categories grey shaded are to be used for hydraulically bound and unbound materials; those in white background are not to be tested and are for information only.