This document applies to manhole tops and gully tops with a clear opening up to and including 1000 mm for installation within areas subjected to pedestrian and/or vehicular traffic. It applies to manhole tops of classes A 15 to D 400 and to gully tops of classes A 15 to C 250 made of composite materials using suitably controlled automatic processes that produce a single structure and that do not contain multiple pieces bonded together. This standard applies to composite materials defined as composite A1, composite A2 and composite B. NOTE 1 Products manufacture by means of hand lay-up methods are outside the scope of the standard. NOTE 2 For applications at constant temperatures exceeding 150 °C additional requirements may be necessary. This part 5 is not applicable in isolation but only in combination with prEN 124-1. This document does not apply for fillings installed on site, eg. concrete, paving blocks etc., for gratings as part of prefabricated drainage channels according to EN 1433, to floor and roof gullies in buildings which are specified in EN 1253 (all parts) and to surface boxes.