This standard includes EN ISO 9001:2008 quality management system requirements and specifies additional aviation maintenance industry requirements, definitions and notes as shown in bold, italic text. NOTE 1 Baseline aviation maintenance requirements originate from IAQG developed 9100:2008 standard; modifications were made, as required, to address maintenance industry specific requirements. It is emphasized that the requirements specified in this standard are complementary (not alternative) to contractual and applicable statutory and regulatory requirements. Should there be a conflict between the requirements of this standard and applicable statutory or regulatory requirements, the latter shall take precedence. This European Standard specifies requirements for a quality management system where an organization: a) needs to demonstrate its ability to consistently provide product that meets customer and applicable statutory and regulatory requirements; and b) aims to enhance customer satisfaction through the effective application of the system, including processes for continual improvement of the system and the assurance of conformity to customer and applicable statutory and regulatory requirements. NOTE 2 In this European Standard, the term "product" only applies to: a) product intended for, or required by, a customer; b) any intended output resulting from the product realization processes. NOTE 3 Statutory and regulatory requirements can be expressed as legal requirements. Application All requirements of this European Standard are generic and are intended to be applicable to all organizations, regardless of type, size and product provided. Where any requirement(s) of this European Standard cannot be applied due to the nature of an organization and its product, this can be considered for exclusion. Where exclusions are made, claims of conformity to this European Standard are not acceptable unless these exclusions are limited to requirements within Clause 7, and such exclusions do not affect the organization's ability, or responsibility, to provide product that meets customer and applicable statutory and regulatory requirements. This standard is intended for use by maintenance organizations whose primary business is providing maintenance, repair and overhaul services for aviation commercial and military products; and for Original Equipment Manufacturer (OEM) organizations with maintenance, repair and overhaul operated autonomously or that are substantially different from their manufacturing/production operations. It is tailored for organizations with National Airworthiness Authority (NAA) repair station certification and those that provide maintenance, repair and overhaul services for military aviation products; but the standard could significantly benefit non-certificated maintenance organizations that choose to adopt it.