This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs in sizes through 24 mm or 1 in diameter inclusive with lengths to 150 mm or 6 in inclusive, having specified minimum tensile strengths of 900 MPa or 120 000 psi and greater, which are primarily intended for use in automotive assemblies. The recommended practice does not include inspection sampling requirements other than for referee purposes.
Số hiệu tiêu chuẩn
SAE J 1061
Tên tiêu chuẩn
Surface Discontinuities on General Application Bolts, Screws, and Studs
Ngày phát hành
2008-02-01
Tiêu chuẩn liên quan
ASTM E 3 (2001)
Từ khóa
Automotive engineering * Bolts * Inspection * Rock anchors * Screws (bolts) * Self drilling screws * Studs * Surface discontinuities * Surface roughness
SAE J 1061
.png)
.jpg){kind=logo}
.jpg){kind=logo}
-_-logo.png){kind=logo}
