This European Standard is applicable to gully tops and manhole tops made of flake graphite cast iron and/or spheroidal graphite cast iron whether in combination with concrete or not, with a clear opening up to and including 1000 mm for covering gullies, manholes and inspection chambers for installation within areas subjected to pedestrian and/or vehicular traffic. It is applicable to manhole tops and gully tops for use in - areas which can only be used by pedestrians and pedal cyclists (at least class A 15); - pedestrian areas and comparable areas, car parks or car parking decks (at least class B 125); - the area of kerbside channels of roads which, when measured from the kerb edge, extends a maximum of 0,5 m into the carriageway and a maximum of 0,2 m into the pedestrian area (at least class C 250); - carriageways of roads (including pedestrian streets), hard shoulders and parking areas, for all types of road vehicles (at least class D 400); - areas imposing high wheel loads, e. g. docks, aircraft pavements (at least class E 600); - areas imposing particularly high wheel loads, e. g. aircraft pavements (class F 900). This European Standard is not applicable in isolation but only in combination with FprEN 124-1 and also gives guidance for combinations of covers/grating made from cast iron with frames according to FprEN 124-3, FprEN 124-4, FprEN 124-5 and FprEN 124-6. This European Standard is not applicable to; - fillings installed on site, e. g. concrete, paving blocks etc; - concave gratings for classes E 600, F 900 and D 400 in carriageways of roads; - gratings/covers as part of prefabricated drainage channels according to EN 1433; - floor and roof gullies in buildings which are specified in EN 1253 (all parts), and; - surface boxes.